What Is The Difference Between Electric And Gas HVAC Systems?

Good Deals Heating and Cooling HVAC systemsAn HVAC system can change your house in a lot of ways, mostly due to the ability to have climate control at your fingertips. HVAC comes with a lot of benefits, but you have to choose which system is right for you. One of the choices you need to make is to determine whether you need an electric HVAC system or a gas HVAC system. Let’s take a look at the differences.

Gas

Surprisingly, a gas HVAC system runs more efficiently than an electric one. You will just need to ensure that you have the proper gas systems. These systems cost more to install and will require someone who is experienced in installing gas systems.

Gas HVAC units can put out more heat efficiently than other HVAC systems. These systems last up to 20 years and are best for cold climates.

For those that are looking to get one of these systems, they will find that they are expensive up front. A gas HVAC unit is also louder and requires more continuous maintenance.

Electric

A lot of people enjoy electric HVAC systems because they are less expensive and easier to install. Units that run on electricity are also inherently safer. You don’t have to worry about gas.  Electricity may be more expensive than gas in some areas of the country. Therefore, this choice may prove more costly in the long run.

One of the significant benefits of electric HVAC units is they last approximately 10 years longer than a gas HVAC unit. They are better for warmer climates.

The higher cost comes with the benefit of being quieter. Just the reduced sound volume can often be a better reason to choose these units.

If you are looking to get an HVAC unit making an informed decision is key. You will want to conduct research to determine which unit is the most reasonable for your needs. While a lot of people are choosing electric HVAC systems in the modern world, there are good reasons to choose a gas HVAC. Make sure to also get an expert opinion before making a final choice.

For more information on HVAC units contact Good Deals Heating and Cooling at 215-947-1166.

Tips for Maintaining a Gas Heating System

Good Deals Heating and Cooling gas heating systemIt’s cold out there, and you are sitting in your house with a great gas heating system. Ideally, you want your gas heating system to keep you cozy for a decade or more. This result can only be made possible with care and maintenance. With a few steps, you can avoid a significant breakdown and keep your heating system running efficiently.

Turn Off the Power

First things first! Safety measures must be on the top of the list. Before getting into the furnace cleaning, you have to take some steps to avoid any mishap. There will be a power switch on the furnace. Turn that off to cut the power and to make the heater safe for maintenance work.

Locate the Filter

Most people find it difficult to find the filter because every gas heating system has a different design so the filter can be anywhere within the system. Usually, it’s in the furnace itself, but some are in the vents.  You either need to look in the owner’s manual (hard copy or online) or if you like a challenge, just look in the furnace or vents in the walls or ceiling.

Take the Filter Out

Once you’ve located the filter all, you have to do take out the filter and note its dimensions. You will need those dimensions when purchasing a new one.

Cleaning or Replacing?

It is recommended that you replace the old filter after a specified time (mentioned below). But if you’re not in a mood for replacing it, then just cleaning will do too. Depending on the type of filter this means vacuuming the filter or running it under water.

How Often Should I Replace My Filter?

It depends on the type of the filter your furnace uses. If you have a polyester or pleated filter, then you should change it every three months. One month for a fiberglass filter. However, if you have an indoor pet or someone who smokes, you should change your filters every month.

Finishing Up

Now that you have a new or cleaned filter at hand your job is almost done, all you have to do is to reverse the entire process. Place the clean filter back in its place and tighten up all the screws if there are any.  Close the furnace or vent, turn on the power again, and you’re done!

This straightforward process will keep your furnace running efficiently and maintain excellent air quality throughout your home.

For help maintaining a gas heating system, contact Good Deals Heating and Cooling at 215-947-1166.