HVAC Can Flood Your House

Good Deals Heating and Cooling HVAC

HVAC units remove heat, cold, and moisture from your house, but this process has an unfortunate by-product in the form of moisture build-up. There is a built-in mechanism designed to address this issue, but sometimes, it fails. When this happens, the unit leaks excessive water—flooding your house. Other problems, such as malfunctioning parts of the HVAC units, can cause moisture build-up as well.

Water Build-up on HVAC Units

While moisture build-up on the HVAC units is perfectly normal, it becomes a problem when it leaks into your house. To better understand this scenario, try pouring cold water into a glass on a hot day. Notice the moisture build-up on the exterior of the glass; eventually, it begins to drip down.

This condensation process happens in your standard AC unit. An AC unit contains an evaporator coil that houses the cold refrigerant. Warm air inside your room is blown over it, cooling the air and causing moisture to build-up on the coils. This moisture then drips into a drip pan and down a condensate drain line that leads out of your home. This process is contained inside the HVAC unit. If you see any water outside the unit, there is a problem.  Listed are a few reasons why there may be water escaping from your HVAC unit.

Clogged Condensate Drain Line

A clogged drain line is the number one cause of water leaks from your AC unit. Accumulated dirt can easily find its way to the drain line with the help of water flow. When this happens, water backs up. Backed water causes further problems because it can create sludge and mold, clogging the line even more and will eventually fill up the drip pan—overflowing the unit.

There are numerous unclogging methods, but a guaranteed way is to have a professional use a vacuum to suck out the blockage material or opt for a drain line with an air vent and P-trap.

Old Damaged Drip Pan

Due to its long service duration, old drip pans can develop rust and holes, so water just falls right through. If this happens, you must replace it with a new drip pan.  Maybe add it to your yearly maintenance routine.

Malfunctioning Condensate Pump

If your HVAC units are located in the basement, it needs a condensate pump to push the water outside your home. But if the pump is malfunctioning, there will be no means to push water outside and will eventually fill up the drip pan—overflowing the unit. Ensure that the condensate pump is functioning soundly.

Dirty Air Filter

Dirty air filters block the smooth airflow of warm air to the evaporator coils. Due to obstructions, an insufficient amount of warm air is blown over the evaporator coils causing it to get too cold and freeze over. The accumulated ice will eventually melt, and the drip pan may not be able to handle the excess water, causing it to overflow. Cleaning your air filter is an easy task, and you need to do it frequently to prevent dirt build-up.

Misaligned Unit Placement

AC units placed on an inclined surface may not allow condensation to drain properly. Instead, install the unit slightly inclined towards the condensate drain line to force the water into the drain line by gravity.

Unsealed Unit

If your AC unit is not sealed completely, warm air can get inside the unit. Excess warm air constitutes excess moisture build-up due to condensation, which can overflow the drip pan. Ensure that your unit is correctly sealed.

If you see water pooling near your HVAC unit, call the professionals at Good Deals Heating and Cooling at 215-947-1166.

Don’t Let the Cost to Replacement Your HVAC Scare You

Good Deals Heating and Cooling HVAC System

If your HVAC is not functioning properly, you might need to replace or repair it.  Having an efficiently running HVAC system keeps energy costs down. Before repairing your system, you might evaluate the option of investing in a newer HVAC. It may be more cost-efficient to replace than to repair.

When Should I Replace My HVAC System?

There are a few indicators that signal that your HVAC system needs to be replaced.

System is 15 Years Old.  A simple rule to keep in mind is that if your system is older than 15 years, it is high time to look for a replacement. Typical HVAC systems will run up to fifteen years without any significant issues. But as the system ages, its efficiency declines.  When the unit becomes less efficient, it is more costly to operate.

Safety Concerns.  Some HVAC systems use gas-based thermal exchange systems. With older systems, gas leaks can occur, which can be hazardous to the household occupants. If this is the problem, replacing an HVAC system is imperative to guard against such dangerous incidents.

Constant Breakdowns.  If you have had to repair your HVAC system multiple times over a short period, then invest in a brand new HVAC system.  A new unit will perform as intended and reduce the operating costs while being environmentally friendlier.

Most people cringe at the cost of replacing their HVAC system, and rightly so.  HVAC units are expensive, but so are numerous repairs, and after repairs you often have to replace the unit anyway.

One example is an HVAC system which has a coolant leak is far more costly to refill frequently than it is to buy a new HVAC system. Prices of R22 coolant refill can cost up to 500 dollars.  With a coolant leak, there is a high probability that the compressor will fail soon. In such a case, it would be more cost-efficient to replace the entire HVAC system instead of having the coolant filled multiple times. These sorts of scenarios should be considered when weighing options between repair and replacement, and so the mere thought of the cost of replacement must not scare you.

For more information on how to know when to replace your HVAC system contact Good Deals Heating and Cooling at 215-947-1166.

Which Is Better: Oil or Gas Heating System?

Good Deals Heating and Cooling heating systemAlthough the choice between oil and gas heating systems is an important one, a surprising number of homeowners hardly give it a second thought. Some people stick to ‘gas only’ policy while others believe there is no other option than oil. Let’s take a look at the characteristics of each of these furnace types.

Features of Oil Heating Systems

In general, oil-powered heating systems can generate more heat compared to any other sources available today. However, this system demands an on-the-site oil storage tank that needs to be filled with oil. Under general circumstances, cleaning and servicing oil-powered heating systems is an easy task. The service is conducted by the oil delivery company, and the customer needs to get into a service agreement/contract to receive such service. However, the maintenance process of the oil heating systems is relatively extensive; these systems gather dirt and soot significantly. To maintain a smooth operation and assure maximum efficiency, you should clean the chimneys and change the oil filters accordingly.

The overall cost to install an oil heating system may be less compared to the gas heating system installation. On the other hand, the overall efficiency of the oil furnaces is lower compared to the gas alternatives. The overall cost to you will have to spend on oil (fuel) will be higher compared to the gas.

Features of Gas Heating Systems

Compared to the oil-powered heating systems, natural gas heating systems feature better efficiency. In addition to the higher level of effectiveness, gas is an affordable fuel compared to oil. Unlike with oil heating systems, however, it is compulsory that your house is located in an area where a gas supply network is available. When it comes to maintenance, gas furnaces demands significantly less attention compared to oil heating systems. Also, gas furnaces don’t need a service contract to get the occasional maintenance done. One of the most notable drawbacks associated with gas heating is that they generate relatively less heat (per BTU) compared to oil. Heating systems powered with gas are remarkably quiet, and the operation is pretty clean. However, the initial cost to install a gas furnace is higher.

For all your heating system needs contact Good Deals Heating and Cooling at 215-947-1166.

 

Know When To Replace Your Heat Pump

Good Deals Heating and Cooling heat pumpAn electric heat pump is a cooling and heating system that uses compressed and decompressed gas to heat or cool a home. This mechanical device can extract heat from the air, water or the earth. It functions as an air conditioner during the summer and a furnace in the winter, by being both a heating and cooling unit in one unit.

Heat pumps are great systems that help keep your home comfortable all year round. It’s important to note that a heat pump doesn’t last forever. Therefore a fair knowledge of knowing when to replace your heat pump is necessary to avoid total failure of the system. Fending off a scenario where your heat pump breaks down beyond repairs in the middle of winter or summer is a smart move.  Not only is that situation uncomfortable, but repairs during high seasons can cost big bucks.  Preventing such an occurrence is wise so look for these four signs that indicate your heat pump needs replacing:

1.  Numerous Repairs

If your heat pump continues to develop fault now and then like say several times a year, you have to consider replacing it. Continuous wear and tear of your heat pump may lead to an unexpected failure when you need it most. When reviewing the cost of replacement, weigh in the amount spent in constant repairs of the system. This calculation may be enough to get you a new heat pump.

 2.  Elevated Energy Bills

A higher energy bill is another sign showing that your heat pump needs replacing. When the heat pump reaches the point where it no longer functions efficiently, it will lead to a drastic rise in your energy bill.  When things reach this stage, no amount of repair can reduce the increase.  It’s time to put the old heat pump to rest and get another one.

3.  Age

Consider the age of your heat pump. Once the heat pump gets over the age of 15-20 years, it is past its prime. Sure, you can still keep it, but at this stage, it will start having frequent faults and perhaps a total breakdown.

4.  Reduced Heating and Cooling

If you notice your heat pump has suddenly reduced its efficiency regarding heating and cooling after several repairs, then it’s a clear sign that you need to replace your heat pump.

Is the heat pump running and running, but you are still cold or hot?  This situation happens especially when the unit has gone past the age of 15. The efficiency reduces to the point that you have to consider replacing it because it will never work properly again.

It’s essential that you inspect your heat pump and watch for these signs. Biannual maintenance checks by a professional HVAC service company will keep your heat pump going as long as possible.  They will also give you a report on how well your heat pump is working and a recommended time to replace it.

You need professionals to installed your heat pump correctly. You don’t have to look further if you need the best professional to install your heat pump, get in touch with Good Deals Heating and Cooling at 215-947-1166 for the best heat pump installation and other general heating and cooling services.

How to Know When to Replace Your HVAC Unit

Good Deals Heating and Cooling HVACHVAC units, just like anything else, have a lifespan to function at an optimal level. Once the unit starts to malfunction, it is time to decide whether to repair it or replace it depending on its condition. Here’s how to know when to replace the HVAC unit.

  1. The unit is older than ten years.  If the unit (either the heat pump or the air conditioner) is older than ten years, the efficiency of the HVAC is in serious doubt. It can be a leading cause of massive electricity bills. Such units can consume up to 20% more energy than the modern units. So, it is wiser to switch for a new HVAC with energy star label.
  2. The furnace is older than 15 years.  Again, if the furnace is older than 15 years, it might be consuming up to 15% more energy than the modern units. In that case, it will cause a huge impact on the electricity bill.  It is better to switch for an Energy Star furnace that consumes less power and delivers more efficiency.
  3. The energy bills are significantly higher for the household.  Older, inefficient HVAC units consume remarkably more energy and perform poorly compared to the new ones. If a particular household’s energy bill is too high, and still runs on decades older HVAC units, it might be the time to think of a replacement.
  4. Equipment breaks down regularly. If the equipment breaks down frequently, it might be a serious annoyance for the residents. This situation should be addressed with a replacement for a trouble-free, comfortable and convenient life.
  5. Some rooms are either too hot or too cold. When an HVAC system malfunctions, it will either work excessively or moderately. Issues related to duct, insulation or equipment installation might be the reasons. Such matters can be adequately addressed with a new HVAC installation.
  6. Non programmable devices.  It is important to install a programmable HVAC unit in order to save energy and assure maximum convenience.   Home automation that includes the heating and cooling system can monitor the home and maintain the proper temperature when people and in and out of the house.  Programmable thermostats save a lot of energy.

Apart from that, if the unit has a very noisy operation, the residents experience humidity imbalance within the house or excessive dust clogs inside the house it might be the time for a HVAC replacement.

Contact Good Deals Heating and Cooling for all your HVAC needs.  Call 215-947-1166.